Sustaining complete home comfort during the colder months is one of the top concerns for a lot of people. Sure, you’d like that to extend year-round, but when winter gets its coldest, it feels a little more essential. The scenario normally unfolds like this: your local Rockford weatherperson is forecasting the coldest day of the year and your furnace decides to stop working. Now there’s no need to panic and call a furnace technician quite yet. There are a number of things you can check on your own before getting ahold of them.
- Ensure your thermostat is set to “heat” – sure, it sounds obvious, but it’s easy to forget to set your thermostat to the correct mode. Whether it’s an unintentional change while cleaning or you had an unexpected rise in temperatures for a few days and didn’t need your thermostat, double check your thermostat’s setting.
- Check your filter – one of the most common causes of furnaces turning off without warning is a dirty filter. When furnace filters get excessively dirty, air cannot pass through them as smoothly. The furnace can detect this and will shut off the system. If you have an older furnace, it may not realize the problem and cause an even bigger headache. Newer furnaces have been developed to pick up on this issue and have a better track record of shutting the system down before it causes any further issues. Getting in the routine of changing your furnace filter every month can make certain you don’t wake up to a chilly house.
- Weak or dead batteries – if your thermostat operates with batteries, check it to ensure there isn’t a flashing low battery signal or another indicator that it’s time to replace your batteries. Other thermostats run off of your home’s electrical system and don’t have to worry about this.
- Check your switches – find your home’s circuit breaker panel and identify the breaker that controls your furnace. You should be able to see if it is in the middle position or the Off position. If it is, cycle the breaker to Off and then re-set it back to the On position. If at any point you feel uncomfortable with the circuit breaker panel, please consult your local Rockford dealer or an electrician.
The other switch to check looks just like a light switch, which could be the issue. It’s your furnace switch and should be in the Up, or On, position. Because of its resemblance to a light switch, it can be easily mistaken for one. Once On, give the furnace a few minutes to kick on as many systems come with built-in delays.
Following these few steps before contacting your local Rockford technician can help you check off the easy things, and if there is still something wrong, it allows you to pass on pertinent information to the technician if they end up coming out. Troubleshooting your furnace doesn’t have to be hard, but ensuring you stay within your comfort zone is key too. There’s no need to take any gambles and potentially do more damage to your furnace, so once you start feeling a little uncomfortable, give your local furnace technician at Temperature Doctors Heating & Cooling, Inc in Rockford a call.